Purpose
When using the DBu Digital Belt Pack Transmitter’s programmable switch function, it is common to require a longer switch for easier use. These instructions describe the steps necessary to attach a switch extension.
Tools You Will Need:
- P1353, Paddle Actuator Extension
- Locktite 380 “BlackMax” or other liquid (not gel) cynoacrylate adhesive (i.e.: Super Glue ®)
- Toothpick(s)
- Paper or cloth (for wiping)
Procedure
Step 1: Identify the location of the programmable switch on the top control panel.
Step 2: Apply a very small droplet of adhesive to the tip of a toothpick and then apply it all around inside the cavity of the P1353, Extension part. Wipe away any excess adhesive from the open face of the part if present.
CAUTION: Use only a small amount of adhesive. Excess will be forced out of the glued interface when applied and may flow onto adjacent switch and/or housing surfaces.
Step 3: Carefully align the P1353 with the switch actuator on the unit and, with the switch moved toward center, push it firmly down over the switch actuator until seated.
Final Step: Move the switch back and forth a few more times to ensure the switch moves freely.
