Skip to content
DNT0212 rackmount audio interface with headphone jack and USB port

DNT0212

Models: DNT0212

  • 32 inputs from DanteTM receive channels
  • 2 analog line level inputs
  • 16 outputs to DanteTM transmit channels
  • 8 line level analog outputs
  • 4 mic/line level analog outputs
  • Supports both switched and redundant modes in DanteTM operation
  • Post-mixing signal processing on all inputs (analog and digital)
  • 48 independent automatic mixers with 38 inputs per mixer and channel activity detectors
  • Support for multi-level mixing: mixes can be looped back and used as mixer inputs
  • Extensive signal processing including filters, delay and channel linking for dynamic processing
    (compressors, limiters)
  • Gain smoothing to prevent transient noise during instantaneous level changes
  • Four test signal generators available for system setup and testing
  • Extensive macro command language
  • Control interfaces via USB, RS-232, Ethernet and programmable logic I/O
  • Rack mount or under table mount
Categories: , ,

Description

The DNT0212 processor subscribes to channels on a Dante network and delivers them to an internal digital matrix for automatic mixing and processing, and to Dante network transmit channels. In addition, two analog line level inputs are provided for use with local sources audio sources such as voice evacuation announcements.

The outputs of the matrix can be assigned to a Dante transmit channel, an analog output and/or routed back to an input to be further mixed and processed with another input channel or matrix mix.

Accessories

Included Accessories

  • 1 – Power Cord (Part #21499)
  • 1 – 25-pin Connector (Part #21558)
  • 7 – 5-position Plug (Part #21580)
  • 1 – USB Cable (Part #21713)
  • 1 – Adjustment Tool (Part #35679)
  • 1 – DNT Software CD
  • 1 – Manual

Accessories

Firmware

Below are links to the current firmware versions for DNT products. These are zip files, after downloading extract them into a temporary folder. Use the DNT Control Panel program to update firmware, instructions are found here.

DownloadFileSizeTypeLast Modified

Firmware History

CLICK HERE FOR DNT FIRMWARE FILES FOR DOWNLOAD

DNT Firmware Update 26Jun2018

  • DNT16i v1.0.6
    1. Fix heat related ‘lockup’ and ‘failure to boot when warm’ problems exhibited by certain units.
  • DNT0212 v1.0.7
    1. Fix heat related ‘lockup’ and ‘failure to boot when warm’ problems exhibited by certain units.

DNT Firmware Update 19Aug2015

  • DNT0212 v1.0.6
    1. Fix bug where special value ’99’ (“don’t change”) didn’t work when used in the “rpoutgn” command. Instead, the value was changed to ‘0’.

DNT Firmware Update 21Apr2014

  • DNT16i v1.0.5
    1. Fix bug where programmable output function “Monitor Input Channel Activity” did not correctly identify the active input channels.

DNT Firmware Update 2Apr2014

  • DNT16i v1.0.4
    1. Fix bug where length of macro commands which are broken across multiple lines using the continuation character ‘_’ are incorrectly limited to 127 characters.
  • DNT0212 v1.0.5
    1. Fix bug where length of macro commands which are broken across multiple lines using the continuation character ‘_’ are incorrectly limited to 127 characters.

DNT Firmware Update 2Dec2013

  • DNT16i v1.0.3
    1. Initial release.
  • DNT0212 v1.0.4
    1. Initial release.

Related Products